A

A

VIKAS WORLD POWERD by VIKAS

Nautral Incrodible of Different Hilarious Important zone

April 25, 2010

PCB

A PCB is a printed circuit board,
also known as a printed wiring
board. It is used in electronics to
build electronic devices. A PCB
serves two purposes in the
construction of an electronic
device; it is a place to mount the
components and it provides the
means of electrical connection
between the components.
A PCB starts out as a thin, non-
conducting sheet of material.
The most common material used
is a glass fiber epoxy laminate
material. A thin layer of copper
is then chemically deposited on
each side of this material.
The next step is to "print" the
connection diagram onto the
PCB. The connection diagram is
the wiring required to connect
the components. In the very
early days of electronics, these
connections were in fact done
with wires. This is the reason
PCBs are also sometimes
referred to as printed wiring
boards. The "printing" is usually
done by photographically
transferring the image to the
PCB. This image is "printed" with
an acid resistant material.
Next, the PCB is put into an acid
bath. The acid bath removes the
copper from the board,
excepting the areas protected
by the resistant material. This
process leaves the connections
or wiring "printed" on the PCB.
Next, holes are drilled in the
board to allow the components
to be mounted to the PCB and
the PCB itself to be mounted to
the case protecting the
electronics. Finally, a protective
coating is applied to the board
to prevent corrosion of the
copper traces.
The above process describes
what is referred to as a doubled
sided or two layer PCB. It is
possible to make PCBs of almost
any number of layers by
repeating the process above and
laminating the resulting PCBs
into a single PCB. The PCB inside
of the computer on which you
are reading this document is a
minimum four layer PCB and
more likely to be an eight or
even 12 layer PCB.
It is also more common now for
parts to be soldered directly to
the board, eliminating the need
for holes into which leads
(wires) from the components
must be inserted. A component
soldered to the board is logically
called a surface mount
component, and the PCB is a
surface mount PCB. This
technique allows a large increase
in the number of components to
be mounted on the same PCB, or
the same number of
components to be mounted on a
much smaller PCB. However,
surface mounting also requires
better quality control on the
manufacture of the PCB.
A PCB is now used in almost
every electronic product
available. It is by far the most
common method currently used
to connect and assemble the
components of almost any
electronic device.

No comments: